Update for: m25, m35, m50, m70, r45, r90, v35

Release notes for Enterprise Monitoring Point version 12.1.0.

Note: This release will be rolled out between April 8 and April 11, so you will see the changes by April 11 at the latest.

Enhancements

  • Mandatory Upgrade!!β€”In order to facilitate a more robust image-based upgrade process that will be available in this and future software releases, all pre-EMP 11.4.0 monitoring points must be upgraded to EMP 11.4.x before upgrading to EMP 12.1.0. If you are running software older than 11.4.0 then you will first need to upgrade to 11.4.x and then upgrade again to get to 12.1.0.

Resolved issues

ID Keyword Description
MP-1084 NTP We fixed an issue where, in some cases, the NTP service on a monitoring point was unable to synchronize with configured NTP servers.
MP-1019 Experience We fixed an issue where web paths could get stuck in a failed state.
MP-1017 API We fixed an issue where documentation for from_port and to_port on the PUT /access_control/acl/ endpoint of the Admin API was unclear. We also added a check to make sure from_port <= to_port.
MP-868 Monitoring We fixed an issue where, under load, a monitoring point could stop monitoring and need to be restarted.
MP-700 Monitoring We fixed an issue where a monitoring point could stop monitoring but remain online and accessible.
MP-504 Usage We fixed an issue where eth1 on an r90 would not show Usage data when configured for out-of-band monitoring.
APM-2542 Video We fixed an issue where video tests over an SD-WAN could fail intermittently.
APM-2481 Setup We fixed an issue where the password configured for a monitoring point using the Add Monitoring Points wizard in APM was not being set on the monitoring point during the USB setup.
APM-2080 Upgrade We fixed an issue where a software upgrade would not complete due to a disk full issue.