Some monitoring point models provide limited packet capture analysis by default. You can enable or disable this analysis if desired.

Enable packet capture analysis

Web admin

  1. Log in to Web Admin.
  2. Navigate to Appliance Configuration > Capture Analysis Configuration.
  3. Select Perform analysis of captures generated by this PathView Appliance.
  4. Click Save.
    • Packet capture analysis is enabled.

Disable packet capture analysis

Web admin

  1. Log in to Web Admin.
  2. Navigate to Appliance Configuration > Capture Analysis Configuration.
  3. Select Do not perform analysis of captures generated by this PathView Appliance.
  4. Click Save.
    • Packet capture analysis is disabled.